


ESB 3.6K3 Tremila Series 3 Way Component Speaker System with Midrange and Tweeters
Couldn't Load Pickup availability
3.6K3
3-Way Speaker System
3.28
1.1"/28 mm Dome Tweeter
The tweeter uses a Torcon® diaphragm for a smooth sound, with an outer suspension covered with a high-loss damping material to eliminate edge vibration and resonance. The dome is of extremely low mass and is much less susceptible to mechanical deformation than other tweeters, yet it provides a smooth, linear and very extended response.
The 28 mm voice coil has an aluminum support and very light copper-coated aluminum wire. The coil is ventilated and damped with iron-fluid oil.
The special SVS ventilation design provides two benefits: optimal cooling of the voice coil and avoiding compressing the air at the back of the dome.
The neodymium N42 magnet, a type of magnet with significantly higher performance than "standard" magnets, is optimized with computer simulations to get better efficiency and improve linearity.
3.90
3.5"/90 mm Cone Midrange
ABS basket reinforced with fiberglass. The basket has been engineered to obtain the maximum in terms of torsional rigidity (resistance to bending), but at the same time, offers the minimum resistance to air passage.
Pressed paper cone with waterproof treatment. It is widely recognized that cones made of paper are the ideal marriage between lightness, stiffness and the ability of the cone to dampen any unwanted vibration (read: distortion).
Twin symmetrical wave rubber surround. The Perbunan® rubber edge is much more stable with temperature changes than standard rubber.
The 20 mm voice coil uses an aluminum support with a double layer winding technology of copper wire with an aluminum core.
High grade ferrite magnet, a type of magnet with significantly higher performance than "standard" magnets.
3.165
6.5"/165 mm Mid-Woofer
ABS basket reinforced with fiberglass. The basket has been engineered to obtain the maximum in terms of torsional rigidity (resistance to bending), but at the same time, offers the minimum resistance to air passage.
Pressed paper cone with waterproof treatment. It is widely recognized that cones made of paper are the ideal marriage between lightness, stiffness and the ability of the cone to dampen any unwanted vibration (read: distortion).
High damping, single wave rubber surround. The Perbunan® rubber edge is much more stable with temperature changes than standard rubber.
The 25 mm voice coil uses an aluminum support with a double layer winding technology of copper wire with an aluminum core.
High grade ferrite magnet, a type of magnet with significantly higher performance than "standard" magnets.
Specification
| Nominal Impedance | 4 Ohm |
|---|---|
| Nominal Power Handling | 90 Watt |
| Transient Power | 180 Watt |
| Frequency Response | 900 Hz ~ 25 KHz |
| Sensitivity | 94 dB 2.83v/1m |
| Nominal Impedance | 4 Ohm |
| Nominal Power Handling | 60 Watt |
| Transient Power | 120 Watt |
| Frequency Response | 150 Hz ~ 7 KHz |
| Sensitivity | 91.5 dB 2.83v/1m |
| Nominal Impedance | 4 Ohm |
| Nominal Power Handling | 120 Watt |
| Transient Power | 240 Watt |
| Frequency Response | 65 Hz ~ 9 KHz |
| Sensitivity | 91.5 dB 2.83v/1m |
More specs
| |
What's Included
- 3.28 Tweeters
- 3.90 Midrange
- 3.165 Woofers
FAQs
Q: Will these speakers fit my car?
A: Most car speakers are standard sizes, but mounting depth and fitting rings vary by vehicle. Check the size in the Specification tab against your vehicle, or contact CEN with your registration and we will confirm fitment and any adapters or fitting kits you need.
Q: Do I need an amplifier to run these speakers?
A: Not always. Most speakers will run from a standard head unit, but a dedicated amplifier lets them perform at their best, particularly for component sets and higher power handling models. The RMS figure in the Specification tab is the guide to how much clean power they can use.
Q: What is the difference between coaxial and component speakers?
A: Coaxial speakers combine the tweeter and woofer in one unit for a simple like-for-like upgrade. Component sets separate the tweeter and woofer with a crossover for better imaging and detail, and suit installs where sound quality is the priority.
Q: Do these come as a pair?
A: Unless stated otherwise, car speakers are sold in pairs. Check the product title and What's Included tab, which lists exactly what is in the box.
Q: Can CEN fit these speakers for me?
A: Yes. CEN offers professional installation from our Nottingham premises. Contact us to book an installation slot or ask for a fitting quote.
About the brand
ESB Audio
Recommended For You
Discover more top-rated gear, handpicked to go with what you're viewing
Looking for Installation?
At CEN we take pride in being able to share the quality of our work as well as being able to show what incredible products we have installed week on week.



Recently Viewed
Jump back to the products you've been checking out































